MI Rear Glass & Frame Replacement
5 people have already completed this repair! Why not you?
Are you having problems loading your Mi mobile phone is no longer detected by the computer and terror the moment of the display issues since it detects is no longer the replacement? This is a question concerning Repairtech.
So, you are in the right place to renew your smartphone and forget about all the loading problems.visit for Mobile glass change.
Our technicians will explain all the activity to reach through this repair guide illustrated and commented to replace the defective connector of the Mi repair center bangalore . You can recharge your smartphone every day with peace of mind. Getting to the gate in smartphone repair to save two to three times the speed of a professional's intevention.
To access or replace internal hardware, the glass back panel must be detached. This disassembly guide will teach you how to safely open up the phone using the required tools listed below.
Note : After checking all the circumstances. further you want to change the Glass & just google for Mi repair Bangalore.
Step 1 Rear Glass & Frame
Make sure you spend at least 5 minutes heating up the adhesive. Prying off the glass cover too early can result in cracking the panel.
Using a heat gun or hairdryer, apply heat approximately three inches above the glass panel to warm up the adhesive around the outside edge of the phone.
Make sure to apply heat evenly across the outside edge of the device.
Note : If you have searching for display replacement. or camera issues.,check for Mobile repair center , one of the best Mi repair center.
Step 2
Be careful not to tear the orange ribbon wire when removing the back panel.
Using a plastic opening tool, gently push up a corner of the rear glass panel.
Slowly slide the plastic opening tool around the outside of the glass panel to break through the adhesive.
Additional plastic opening tools can be used to help separate the back panel from the phone body.
Gently lift the back panel off once all the adhesive has been removed.
step 3
Using a Phillips PH00 screwdriver, remove the silver Phillips 3.5 mm screw circled in red.
Using a spudger, gently lift off the small metal tab that was held in place by the screw.
Gently pry off the orange ribbon wire on the back panel.
step 4
Keep the tiny screws on a magnetic pad or a designated area so they will not be lost. There are eighteen screws in total.
Using a Phillips PH00 screwdriver, remove the eight silver Phillips 3.5 mm screws circled in red.
Using a Phillips PH00 screwdriver, remove the six black Phillips 4.0 mm screws circled in orange.
Using a Phillips PH00 screwdriver, remove the single silver 3.0 mm Phillips screw circled in yellow.
Using the Phillips PH00 screwdriver tip, gently scratch away the white stickers outlined in green circles to expose hidden screws.
Using a Phillips PH00 screwdriver, remove the two black Phillips 4.0 mm screws circled in green.
step 5
Slowly slide the plastic opening tool around the perimeter of the inner lining.
Additional plastic opening tools can be used to help separate the inner lining from the phone body.
Gently pull the inner lining up to remove it from the phone body.
